Ubicación:2-C-6-3
Código:819543
Test Easy Strips 6-in-1/ 100 Pruebas %
ESPAÑOL: Tetra.EasyStrips. Prueba en forma de Tiras 6 en 1 para acuarios de agua dulce y agua salada. En 60 segundo revisa el control de: cloro, nitrito, nitrato, pH, alcalinidad, dureza. Instrucciones: 1.Retire la tira reactiva del frasco y coloque la tapa firmemente. 2. Sujete la tira de un extremo y muévalo de lado a lado en el agua del acuario durante 10 segundos. 3. Retire y sacude el exceso de agua de la tira. 4. Compare inmediatamente con el grafico de colores. Importante: Mantenga la tapa bien cerrada entre usos. Conservar a temperatura ambiente. No lo exponga a la humedad. No retire agente de secado de la botella como resultados de las pruebas pueden no ser exactos en el tiempo. Mantener fuera del alcance de los niños. Se refieren a la parte inferior de la botella cerrada el número de lote y fecha de caducidad. Nota: Para una lectura más precisa, comparar los resultados con el grafico de colores en el frasco cerrado.
ENGLISH: Tetra. Easy Strips. For freshwater and Saltwater Aquariums. 6 in 1 Aquarium Test Strips.Complete all in one testing. 60 second check of: Chlorine, Nitrite, Nitrate, pH, Alkalinity, Hardness. Instructions for using tetra EasyStrips 6 in 1 Aquarium Test Strips: 1. Remove one test strip form bottle and replace cap tightly.2. Hold strip at end with no pads. Dip strip into aquarium water for one second.3. Do not shake excess water from strip.4.Hold strip level for 60 seconds.Compare test strip colors to scale on bottle. Important: Keep cap on bottle tightly between uses. Store at room temperature. Do not expose to moisture. Do not remove drying agent from bottle as test results may not be accurate over time. Keep out of reach of children. Refer to the bottom of enclosed bottle for lot number and use by date.
ENGLISH: Tetra. Easy Strips. For freshwater and Saltwater Aquariums. 6 in 1 Aquarium Test Strips.Complete all in one testing. 60 second check of: Chlorine, Nitrite, Nitrate, pH, Alkalinity, Hardness. Instructions for using tetra EasyStrips 6 in 1 Aquarium Test Strips: 1. Remove one test strip form bottle and replace cap tightly.2. Hold strip at end with no pads. Dip strip into aquarium water for one second.3. Do not shake excess water from strip.4.Hold strip level for 60 seconds.Compare test strip colors to scale on bottle. Important: Keep cap on bottle tightly between uses. Store at room temperature. Do not expose to moisture. Do not remove drying agent from bottle as test results may not be accurate over time. Keep out of reach of children. Refer to the bottom of enclosed bottle for lot number and use by date.
Plaquitas
Vea Nuestro Catálogo de Plaquitas Aquí